If you want to connect two Liberator potentiometers to a single Hyperswitch, you can easily do so with a few steps. The Liberator potentiometers allow you to control parameters like volume or modulation, while the Hyperswitch helps route signals or controls multiple effects. Here’s how to set them up:

  1. Prepare Your Gear: Make sure you have both the Liberator potentiometers and the Hyperswitch on hand. Also, you’ll need some patch cables to connect everything together.
  2. Identify Input and Output Ports: On the Hyperswitch, identify the control input ports where the potentiometers will connect. These are typically labeled “Input” or “Control”.
  3. Connect the Potentiometers:
    • Take the first Liberator potentiometer and connect its output (usually a 1/4″ jack or specific connector) to one of the Hyperswitch input ports.
    • Repeat the same for the second Liberator potentiometer, plugging it into another available input on the Hyperswitch.
  4. Ensure Correct Wiring: Double-check that all connections are secure and that each potentiometer is plugged into the corresponding control input on the Hyperswitch.
  5. Test the Setup: Power on your system and test the functionality of both potentiometers. Adjust each Liberator potentiometer and see how they control the parameters routed by the Hyperswitch.

This setup allows you to control multiple effects or parameters simultaneously with each potentiometer, giving you a more dynamic control experience.